Armasight PVS-7 Wartungshandbuch PDF herunterladen (Seite 25)

NOTE:

It may be necessary to remove the brow pad when wearing the head mount over a protective

mask.

J. Installation of the Head Mount Assembly with the PASGT Helmet. Install the head mount assem-

bly per the instructions in paragraph 3.3.1, H.

K. Installation of the Head Mount Assembly with the M1 Helmet. Install the head mount assembly

per the instructions in paragraph 3.3.1. I.

L. Installation of the Helmet Mount Assembly (Optional) to the PASGT Helmet.

1. Remove mount assembly from the carrying case. Refer to Figure 3-7 for the helmet mount features.

2. With the catch ipped forward, place the strap over the top of the helmet, center and hook the rear

bracket onto the rear of the helmet. Center the front bracket, hook in on the front of the helmet and

hold it in place. (See Figure 3-7.)

3. With the buckle-lever open, take up the slack in the strap using the catch. Close the buckle lever.

4. Place the helmet upside down with the helmet mount facing you.

NOTE:

Steps 5 and 6 describe the installation of the neck strap to the chin strap. To accomplish these

steps, it may be necessary to unthread the chin strap from the helmet.

5. Thread the chin strap through the right end of neck strap and snap the neck strap fastener tab closed.

(Refer to Figure 3-8.)

6. Thread the chin strap through the left end of the neck strap and snap the neck strap fastener tab

closed. (Refer to Figure 3-8.).

7. Unfasten the neck strap latch on the left side of the neck strap.

8. Put the helmet on.

9. Fasten the neck strap with the neck strap latch. Tighten the chin strap and neck strap until they t

securely. The brow of the helmet should be parallel to the ground.

front bracKet

rear

bracKet

SocKet

SIde button

tIlt

adjuStment

Strap

helmet

catch

bucKle

lever

FIGURE 37. HELMET MOUNT FEATURES

Shop for Armasight products online at:

1.877.766.5412

www.SCOUTBASECAMP.com

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 43 44

Keine Kommentare

Armasight PVS-7 Wartungshandbuch Seite 25