3.3.2 INSTALLATION OF THE QUICK DISCONNECT HELMET MOUNT
ASSEMBLY
1. Remove the helmet mount assembly from the carrying case. Make sure the helmet mount is com-
plete. Refer to Figure 3-9 for helmet mount components and features.
CAUTION:
To prevent possible equipment damage, remove both the goggles and the mount assembly
from the helmet when not required for immediate use. The clip/ strap assembly can remain in
place on the helmet.
2. If the mount assembly and clip/ strap assembly are connected, remove the mount assembly. To do
this, push the release lever at the top center of the mount and slide the two assemblies apart.
3. Adjust the clip/ strap assembly to t the helmet size being used.
4. With the catch in the fully extended, place the strap over the top of the helmet, center and hook the
rear bracket onto the rear of the helmet. Center the front bracket hook on the front of the helmet
and hold it in place.
5. With the buckle lever open, tighten the slack in the clip/ strap assembly using the catch. Close the
buckle lever.
6. If the PASGT helmet has its cloth cover and camouage strap installed, it will be necessary to slide the
camouage strap up (at an approximately 30°-45° angle) at the front of the helmet (see Figure 3-9).
nape Strap faStener tabS
nape
StrapS
chIn Strap
Loop the nape strap fastener tabs around the corners
of the chin strap and snap closed. After closure, the
snaps will be on the outside, away from your chin.
FIGURE 38. NAPE STRAP INSTALLATION
SocKet
tIlt adjuStment
mountIng
clIp
helmet
releaSe lever
FIGURE 39. QUICK DISCONNECT HELMET MOUNT FEATURES
Shop for Armasight products online at:
1.877.766.5412
www.SCOUTBASECAMP.com
Kommentare zu diesen Handbüchern